New Multicolor+ technology

#1

We swapped from the UV inkjet printers used by Mimaki to the J750 of Stratasys.
Read more about it in our blog : https://i.materialise.com/blog/en/multicolor-3dprinting-improved/

#2

Interesting. The blog post does not mention the change of hardware. So basically we are back to trying out what the print looks like and how well they hold up (and I was quite pleased with the Mimaki prints so far)… Acceptable for a trial material, but I believe you should be more upfront about this.

#3

Err, post edited in response to remove that bit of information ? Sad.

#4

hi mkroeker,
I understand your reaction.
I reverted the message to the original post.

#5

Thanks, appreciated. Not sure I understand the semi-secrecy though - at least one of the early blog posts about multicolor+ did mention the (then) manufacturer name.